Fitting The Circle Guide (Trammel); Using The Roller Guide - Clarke CR4 Operation & Maintenance Instructions Manual

6. Fit the router bit at the correct height position suitable for the template or
jig to be used.
7. Make the cut as required carefully following the template or jig pattern.

FITTING THE CIRCLE GUIDE (TRAMMEL)

The Circle Guide allows accurate
circles and arcs to be cut.
1. Slide a guide rod into the sockets
in the top of the base plate.
2. Tighten the guide rod locking
knobs to secure the rod.
3. Fit the Circle Guide onto the end
of the guide rod with the point
facing downwards so that it is
positioned on the correct side of
the router for the cut that you intend to make.
4. Assemble the screw and wing nut
on the Circle Guide as shown.
5. Adjust the screw and wing nut
until the pivot point on the screw is
touching the workpiece.
6. Ensure the Circle Guide assembly
is held securely on the guide rod
by tightening the screw or wing
nut.
7. Adjust the guide rod position in
the router base to achieve the required length (radius) from the anchor
position to the centre of router bit.

USING THE ROLLER GUIDE

The Roller Guide attaches to the
parallel guide. It enables the router to
follow the curved shape of the wood.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
18