Switching The Headphones On And Off - Sennheiser 502873 Instruction Manual

Using the RS 160
1s
5s
20

Switching the headphones on and off

WARNING Danger due to high volumes!
Listening at high volume levels for long periods can lead to
permanent hearing defects.
Before putting the headphones on, set the volume to a low
level.
Do not continuously expose yourself to high volumes.
Switching the headphones on
Press the multi-function button
The headphones switch on. The multi-function LED
indicating that the headphones are in enrollment mode.
Once the headphones have found a suitable transmitter, the
transmitter pairs with the headphones and transmits an audio signal.
The multi-function LED
LED of the transmitter flash slowly.
2
Switching the headphones off
Press the multi-function button
The multi-function LED
mode.
If there is no signal from the transmitter for more than 5 minutes,
the headphones automatically switch to standby mode.
´
for approx. 1 second.
º
of the headphones and the multi-function
º
´
´
for approx. 1 second.
º
goes off. The headphones are in standby
º
flashes green,