Panasonic TH-103PF12E Service Manual page 53

3. C heck that the Ve Mode is set to 3.
4. Pless R button and then select and display Ve Init.
5. C heck TPVE and adjust the volume.
6. Exit the IIC mode.
10.1.7. Ve Life adjustment
10.1.7.1. After exchange both D board and DN board
1. Select Ve Mode by IIC mode. (See chap. 10.1.6.)
2. C heck that no bright points appears on the display.
3. If bright points appears, change Ve Mode until bright points disappears.
4. Exit the IIC mode.
Note: If bright/ nolit points still appears, set Ve Mode to 3.
10.1.7.2. After exchange Plasma Display Panel
1. Select Ve Mode by IIC mode. (See chap. 10.1.6.)
2. C heck that the Ve Mode is set to 3.
3. C heck that no bright/nolit points appears on the display.
4. Exit the IIC mode.
10.1.8. Bright or Nolit appears on the display
1. Select Ve Mode by IIC mode. (See chap. 10.1.6.)
2. C heck and rem ember the value of Ve Mode.
3. If bright points appears, change Ve Mode lower until bright points disappears.
4. If nolit points appears, change Ve Mode upper until nolit points disappears.
5. C heck that no bright/nolit points appears on the display, then exit the IIC mode.
Note: If bright / nolit points still appears, set back Ve Mode to the value you remembered above.
Ve M o d e :3
Ve Init
53
TH-103PF12E