Panasonic TH-103PF12E Service Manual page 52

TH-103PF12E
10.1.3. P.C.B. (Print Circuit Board) and Plasma Display Panel exchange
10.1.3.1. Quick adjustment after P.C.B. and Panel exchange
1. To remove P.C.B., w ait 10 minute after power was off for discharge from electrolysis capacitors.
10.1.3.2. Quick adjustment after P.C.B. exchange
Adjust the following voltages with the multimeter.
P.C.B.
P Board (M ain_1) Vsus
Vda
P Board (M ain_2) Vsus
Vda
SC Board Vad
Vscn
SS Board Ve**
D, DS Board W hite balance and Sub brightness for NTSC, PAL, HD, PC and 625i signals
DN Board Set M arket Select N um ber to correct destination by MS mode. (See chap. 6.1.5)
D, DN Board Set Ve Mode until bright points disappears by IIC mode.
*See the Panel Label.
**See chap. 10.1.6.
***See chap. 10.1.7.1.
10.1.3.3. Quick adjustment after Plasma Display Panel exchange
Adjust the following voltages with the multimeter.
Name
V sus (SC Side)
V sus(S S Side)
Ve Life
*See the Panel Label.
10.1.4. Vsus adjustment
After exchange P board or Plasma Display Panel, see the Panel Label and check TPVSUS and adjust the volume.
10.1.5. Vad adjustment
After exchange SC board, check TP9 and adjust the volume.
10.1.6. Ve adjustment
1. After exchange SS board, connect the multim eter to the testpoint TPVE(SS).
2. Select Ve M ode by IIC mode. (See chap. 6.1.1., and 6.2.)
Name Test Point
TP V S U S (SC)
TP 9 (P_M ain_1)
TP V S U S (SS)
TP 9 (P_M ain_2)
TPVAD (SC)
TP VSCN (SC)
TPVE (SS)
Test Point
TP V S U S (SC) V sus ± 2V
TP V S U S (SS) V sus ± 2V
C heck Ve Mode. (See chap. 10.1.7.2.)
Voltage
V sus ± 2V VR251 (P_M ain_1)
70 V +1V, -2V Fixed
V sus ± 2V VR251 (P_M ain_2)
70 V +1V, -2V Fixed
-1 35V ± 1V V R 16600 (SC)
V ad_base:+145V ±4V Fixed
G N D _base: +10V±6V
Ve ± 1V VR16001 (SS)
Voltage Volume
VR251 (P_M ain_1)
VR251 (P_M ain_2)
52
Volume R em arks
*
*
*
***
R em arks
*
*