Panasonic TH-103PF12E Service Manual page 13

6.1.2. CD mode
Select the CD mode by Up/Down button on the remote control at the front page of CAT mode and then press the Mute button on
the remote control more than 3 seconds.
CD
M O N ITOR-MCU
MONITOR-EEPROM
MONITOR-EEPROM Change Addr
PANEL-MCU
PANEL-EEPROM
PANEL-FPGA
PANEL-PDROM
BOARD EEPROM *****
BOARD
PTCT
Memory data change
Address
The data is memorized when switch off the main power.
To exit the CD mode, press the R button on the remote control.
6.1.3. NW mode
Note :
To use the network function, set each "N etwork Setup" setting and make sure to set the "Control I/F Select" to "LAN".
Select the IIC mode by Up/Down button on the remote control at the front page of CAT mode and then press the Action button on
the remote control.
To exit the NW mode, press the R button on the remote control.
Data
Change by Left/Right buttons on the remote control.
Data
0
1.0000Ғ12 і O K ; ^
53. 00 1 і 16 2B :
4,-------------- i_
00 01
01 *
01 ж
Ч ч
1.08
30. 27
11.02
30. 09
------ ------
00. 00. 00. 00. 00. *
. Change by Up/Down buttons on the
remote control.
0 ■ Change by VOL Up/Down buttons on the
remote control.
13
--- Factory use
New data
Original data
-- - SOS history
TH-103PF12E