Quadra-Fire Classic Bay 1200 Service Manual page 13

USING THE TEST BOX:
1) UNPLUG THE STOVE, REMOVE THE CONTROL BOX AND INSTALL THE TEST BOX.
2) INSTALL A JUMPER WIRE ON THE #1 SNAP DISC (PURPLE WIRES) AND THEN PLUG THE STOVE IN.
3) TURN ON THE CONVECTION BLOWER SWITCH.
A. IF BLOWER COMES ON: REPLACE #1 SNAP DISC OR THE CONTROL BOX
B. IF BLOWER DOESN'T COME ON: CHECK WIRE HARNESS OR REPLACE BLOWER
TEST BOX (AS IT IS INSTALLED IN THE STOVE)
USING THE COMPONENT TEST CORD:
1) UNPLUG THE CONVECTION BLOWER FROM THE WIRE HARNESS.
2) INSTALL THE FEED MOTOR ADAPTER WIRE TO THE TEST CORD.
3) PLUG IN THE TEST CORD TO THE CONVECTION BLOWER AND TURN THE SWITCH ON.
NOTE: THIS WILL ONLY TEST THE HIGH SPEED CIRCUIT OF THE BLOWER.
TEST CORD w/ ADAPTER
7-31-2002
CB1200-I PELLET STOVE SERVICE MANUAL
CONVECTION BLOWER TESTING
CONVECTION BLOWER
SWITCH
SNAP DISC #1
JUMPER WIRE
TEST CORD CONNECTED TO THE BLOWER
PAGE 13 250-7700