Changing The Display - Sony MHC-GTR888 Operating Instructions Manual

For Recording Timer:
Tune to the preset radio station
(page 14).
2
Press CLOCK/TIMER SET.
3
Press ./> repeatedly to
select "PLAY SET" or "REC
SET", then press ENTER.
4
Set the time to start playing or
transferring.
Press ./> repeatedly to set the
hour/minute, then press ENTER.
5
Use the same procedure as in
step 4 to set the time to stop
playing or transferring.
6
Press ./> repeatedly to
select the sound source you
want, then press ENTER.
For Recording Timer:
Connect a transferable USB device to
the B port on the unit.
7
Press "/1 to turn off the system.
To check the timer setting or
activate the timer again
Press CLOCK/TIMER SELECT, press
./> repeatedly to select "PLAY
SELECT" or "REC SELECT", then press
ENTER.
To cancel the timer
Press CLOCK/TIMER SELECT, press
./> repeatedly to select "TIMER
OFF", then press ENTER.
Notes
• The system turns on before the preset time. If
the system is turned on at the preset time or if
"STANDBY" flashes in the display panel, the
Play Timer and the Recording Timer will not
play or transfer.
• Do not operate the system from the time the
system turns on until the playback or
transferring starts.

Changing the display

Changing the display mode
Press DISPLAY on the remote
control repeatedly while the
system is turned off.
Demonstration
The display changes and the indicator
flashes even when the system is turned
off.
No display (Power Saving Mode)
The display is turned off to conserve
power. The timer and clock continue to
operate. You cannot turn on the system by
pressing the function buttons.
Clock
The clock display automatically turns to
Power Saving Mode after a few seconds.
Changing the illumination
pattern around VOLUME/DJ
CONTROL knob
1
Press OPTIONS.
2
Press / repeatedly to select
"ILLUM", then press ENTER.
3
Press / repeatedly to select
the illumination pattern you
want, then press ENTER.
To exit the OPTIONS menu, press
OPTIONS.
GB
23