Sony MHC-GTR888 Operating Instructions Manual page 27

Speakers
Sound comes from one channel or
unbalanced left and right volume.
• Place the speakers as symmetrically as
possible.
• Check that the speakers are connected
securely and correctly.
• The source being played back is
monaural.
There is no sound from a specific
speaker.
• Check that the speaker is connected
securely and correctly.
• (MHC-GTR888/MHC-GTR777/
MHC-GTR555 only) Set the subwoofer
level to the appropriate level (page 21).
Disc player
The disc tray does not open and
"LOCKED" appears in the display
panel.
• Consult your nearest Sony dealer or
local authorized Sony service facility.
The disc tray does not close.
• Load the disc correctly.
The disc does not eject.
• You cannot eject the disc during
CD-USB Synchronized Transfer or
REC1 Transferring. Press x to cancel
the transferring, then press Z OPEN/
CLOSE to eject the disc.
• Consult your nearest Sony dealer.
Playback does not start.
• Wipe the disc clean (page 31).
• Reload the disc.
• Load the disc that this system can play
back (page 25).
• Remove the disc and wipe away the
moisture on the disc, then leave the
system turned on for a few hours until
the moisture evaporates.
The sound skips.
• Wipe the disc clean (page 31).
• Reload the disc.
• Move the unit to place without vibration
(e.g., on top of a stable stand).
• Move the speakers away from the unit,
or place them on separate stands. When
you listen to a track with bass sounds at
high volume, the speaker vibration may
cause the sound to skip.
Playback does not start from the first
track.
• Set the play mode to Normal Play
(page 12).
The folder name, track name, file
name and ID3 tag characters do not
appear properly.
• Use a disc that conforms to ISO9660
Level 1/Level 2, or Joliet (expansion
format).
• The ID3 tag is not Version 1(1.0/1.1)
and Version 2(2.2/2.3).
• The character code that can be displayed
by this system are as follows:
– Upper cases (A to Z)
– Numbers (0 to 9)
– Symbols (< > * +, [ ] \ _)
Other characters appear as "_".
USB device
Transferring results in an error.
• You are using an unsupported USB
device. Check the information on the
websites about compatible USB devices
(page 15).
• The USB device is not formatted
correctly. Refer to the operating
instructions supplied with the USB
device on how to format.
• Turn off the system and remove the
USB device. If the USB device has a
power switch, turn the USB device off
and then on again after removing it from
the system. Then perform transferring
again.
l
Continued
27
GB