Table of Contents
Advertisement
CRS-300 1:10 Redundancy Switch
Introduction
Notes (as of April 2007):
1) Use CRS-316 instead of CRS-315. To maintain older TMIs in the field, Switch
firmware must also support the CRS-315.
2) Use CRS-336 instead of CRS-335. To maintain older TMIs in the field, Switch
firmware must also support the CRS-335.
3) Use CRS-306 instead of CRS-305. To maintain older RMIs in the field, Switch
firmware must also support the CRS-335.
For modems where the terrestrial data type is Ethernet, you can use only one
4)
Ethernet port in Single-port Ethernet Bridge Mode, on the modem rear panel (when
using the optional Ethernet interface).
1.3.3.3.2.1
RMI Cards
Figure 1-14. CRS-305 RMI
(PL/11494-1)
Figure 1-15. CRS-306 RMI
(PL/11494-2)
Figure 1-16. CRS-307 RMI
(PL/11494-3)
DB-25 Male
(2X) BNC Male
HD-50 Female
10/100/1000
(2X) BNC Male
HD-50 Female
DB-25 Male
HD-50 Female
1–13
MN/CRS300.IOM
DB-15 Male
HD-15 Female
DB-15 Male
HD-15 Female
DB-15 Male
RJ-45
HD-15 Female
Revision 19
Advertisement
Table of Contents
