Communication - ABB Endura AZ series User Manual

Endura AZ series integral and remote transmitter
Combustion oxygen monitor

5.4.8 Communication

Menu
Communication
Exit
Parameter
HART
HART Poll Address
HART Device ID
HART Tag
HART Device Message Used to specify a a user-defined message for the HART
HART Descriptor
Device Install Date
Final Assembly No.
Table 5.13 Communication Menu
IM/AZ20E–EN Rev. F
Used to configure HART communication parameters and
8
cyclic output communication via the IrDA interface on the front
of the transmitter.
Select
Comment / [Range]
Used to enter a unique device address.
When set to 0, Current Output 1 is active and provides
an analog output proportional to its source. HART
operates in point-to-point mode.
If set between 1 and 15, Current Output 1 is fixed at 4
mA and HART operates in multi-drop mode.
Note. See Section 7.2, page 69 for multi-drop
configuration details.
[0 to 15]
The unique ID for the HART device.
Used to enter a user-defined tag for the HART device
(transmitter), selected from the alphanumeric character
set displayed when the Edit button is selected at this
sub-parameter.
[0 to 8 characters]
device (transmitter), selected from the character set
displayed when the Edit button is selected at this
sub-parameter.
[0 to 16 characters]
Used to specify a unique HART descriptor, selected from
the character set displayed when the Edit button is
selected at this sub-parameter.
Maximum of 32 characters.
The time and date of installation.
The device's (transmitter's) final assembly (ID) number.
5 Programming
Default
0
Factory-set
read-only ID
N / A
N / A
N / A
User-set
Factory-set
61