Safety; Health & Safety; Electrical Safety - Cei / Iec 61010-1:2001-2; Symbols - Cei / Iec 61010-1:2001-2 - ABB Endura AZ series User Manual

Endura AZ series integral and remote transmitter
Combustion oxygen monitor

1 Safety

Information in this manual is intended only to assist our customers in the efficient operation of our
equipment. Use of this manual for any other purpose is specifically prohibited and its contents are not to be
reproduced in full or part without prior approval of the Technical Publications Department.
1.1 Health & Safety
Health and Safety
To ensure that our products are safe and without risk to health, the following points must be noted:

The relevant sections of these instructions must be read carefully before proceeding.

Warning labels on containers and packages must be observed.

Installation, operation, maintenance and servicing must only be carried out by suitably trained
personnel and in accordance with the information given.

Normal safety precautions must be taken to avoid the possibility of an accident occurring when
operating in conditions of high pressure and / or temperature.

Chemicals must be stored away from heat, protected from temperature extremes and powders
kept dry. Normal safe handling procedures must be used.

When disposing of chemicals ensure that no two chemicals are mixed.
Safety advice concerning the use of the equipment described in this manual or any relevant Material
Safety Data Sheets (where applicable) may be obtained from the Company address on the back cover,
together with servicing and spares information.
1.2 Electrical Safety – CEI / IEC 61010-1:2001-2
This equipment complies with the requirements of CEI / IEC 61010-1:2001-2 'Safety Requirements for
Electrical Equipment for Measurement, Control and Laboratory Use' and complies with US NEC 500, NIST
and OSHA.
If the equipment is used in a manner NOT specified by the Company, the protection provided by the
equipment may be impaired.
1.3 Symbols – CEI / IEC 61010-1:2001-2
One or more of the following symbols may appear on the equipment labelling:
Protective earth (ground) terminal.
Functional earth (ground) terminal.
Direct current supply only.
Alternating current supply only.
Both direct and alternating current supply.
IM/AZ20E–EN Rev. F
1 Safety
3