4IPNET, INC. You may not alter or remove any copyright or other notice from copies of the content. All other brand and product names are claimed or registered marks of their respective companies or organizations.
Page 4
This declaration is only valid for configurations (combinations of software, firmware, and hardware) provided and supported by 4ipnet Inc. The use of software or firmware not provided and supported by 4ipnet Inc. may result in the equipment no longer being compliant with the regulatory requirements.
EAP738 Enterprise Access Point ENGLISH Preface Package Contents 4ipnet EAP738 is a high-end, dual radio 802.11 1. 4ipnet EAP738 x 1 b/g/n + ac (Wave 2) MIMO Access Point (AP) with 2. Handbook x 1 the best performance for business and industrial 3.
Page 8
EAP738 Enterprise Access Point ENGLISH Power LED EAP738 status. The Status LED will start blinking when the restart/reset button is pressed. For the first 5 seconds, the LED will blink slowly (restart), and after 5 seconds, the LED will start blinking quickly (reset).
(a) Mounting on a Wall 1. Set two screws in the wall 128 mm (5.0 in.) apart. 2. Slide EAP738’s wall mounting slots down onto the screws so that the unit is secure. (b) Mounting on a Ceiling T-Bar 1. Use the included screws to attach two ceiling-mount T-bar clips to the back of EAP738.
Page 10
2. Connect EAP738 to your network device. Connect one end of the Ethernet cable to the Uplink (PoE) port of EAP738 and the other end of the cable to a switch, a router, or a hub. EAP738 is then connected to your existing wired LAN network.
1. To access the Web Management Interface, connect the administrator PC to the Uplink port of EAP738 via an Ethernet cable. Then, set a static IP address on the same subnet mask as EAP738 in TCP/IP of your PC, such as the following example: IP Address: 192.168.1.100...
Page 12
H H andbook EAP738 Enterprise Access Point ENGLISH 4. After a successful login to EAP738, a System Overview page of the Web Management Interface will appear, as depicted below. The Web Management Interface - System Overview Page 5. To logout, simply click on the Logout button at the upper right hand corner of the interface to return to the Administrator Login Page.
Page 17
ENGLISH Step 4. Configure WDS (Wireless Distribution System) Settings (Optional) To extend the wireless coverage, EAP738 supports WDS links on each RF card for connecting wirelessly to other WDS-capable APs (peer APs). By default, all WDS profiles are disabled. ¾ Click on the Wireless button on the main menu.
Page 18
Congratulations! Now, 4ipnet EAP738 is installed and configured successfully. After EAP738's network configuration is completed, please remember to change the IP Address of your PC Connection Properties back to its original settings in order to ensure that your PC functions properly in its real network environments.