Table of Contents
Advertisement
CONNECTIONS
(Fig. 2)
@imsio
PRECAUTIONS
If water should enter the unit, electrical
shock or malfunction
may
result. Always use it in a place where there is low humidity and little
dust.
Do not use where there are extremes of temperature
(below 5°C or
exceeding 35"C) or where direct sunlight may strike it.
Because of the CD player's extremely low noise and wide dynamic
range, there might be a tendency to set the volume on the amplifier
unnecessarily
high, Doing so may produce an excessively
large
output from the amplifier which could damage your speakers.
Sudden changes in the ambient temperature maycausecondensation
to form on the optical lens inside the unit. If this happens, take out the
disc, leave the unit for about 1 hour, and then proceed to operate.
When carrying the unit, be sure to remove any discs which may
be inside and turn the power off. The STANDBY indicator lights.
Then unplug the mains lead from the AC outlet. Carrying the unit
with any discs inside may damage the discs andlor the unit.
The system's speakers use powerful magnets. Do not place timepieces,
credit cards, cassette tapes or video tapes, etc. near the speakers.
Do not install this equipment in a confined space, such as a book case
or built in cabinet.
Note:
Do not connect the mains lead to an AC outlet until all connections
have been made.
The system is not completely disconnected
from the mains when the
WON button is set to the o position.
When the unit is first connected, the display switches automatically
to the
demonstration
mode. To cancel this mode, turn the power on or press the
DISPLAY button.
Speakers
Connect the front speaker leads to the FRONT SPEAKERS
terminals.
Connect the centre speaker leads to the CENTER SPEAKER terminals.
Connect the surround speaker leads to the SURROUND
SPEAKERS
terminals.
Note:
-
When connecting the speakers, make sure that (+) and (-) polarities
are matched properly. Otherwise, the sound may appear to be lacking
in the bass range and in stability.
Connect the speaker wire with the stripe to the red terminal(+)
and the
other wire to the black terminal (–).
If desired, the front speaker grilles can be removed.
FM
aerial
The FM indoor aerial is sufficient to receive most local FM broadcasts and
should be connected to the FM 75 ohm terminal. Extend the aerial wire as
straight as possible and, while listening to the sound from the system,
secure it in a position which yields minimal distortion and noise.
In fringe areas or where reception is distorted or noisy, an FM outdoor
aerial (not supplied) should be connected instead of the indoor aerial. The
terminals will accept 75-ohm coaxial cable. Consult your dealer.
AM
loop aerial
Assemble the loop aerial as shown in Fig, 3a. Unwind the aerial wires, then
connect them to the AM LOOP terminals. Place the loop aerial in a position
which yields the best AM reception, or attach it to a wall or other surface
as shown in Fig. 3b.
Note:
To minimize noise, the speaker, mains and any other leads should not
come close to the FM indoor or outdoor aerial lead and AM loop aerial. Do
not place the aerial leads close to the system.
Video equipment/DVD
player
Connect audio leads (not supplied) from the audio output sockets of a
video equipmenVDVD
player to the VI DEO/DVD IN sockets.
Headphones
Connect stereo headphones
(not supplied)
to the PHONES socket for
monitoring
or for private
listening.
The speakers
are automatically
disconnected
when headphones
are connected.
Subwoofer
Connect an amplified
subwoofer
(not supplied)
to the SUB WOOFER
socket.
6
Advertisement
Table of Contents
