Table of Contents
Advertisement
PROGRAMMED
PLAY
Up to 32 selections, from up to 3 discs, can be programmed for play in any
order.
To begin the programming
procedure, select "CD" function first.
The discs or tracks must be programmed
in the stop mode.
The same disc or track can be programmed
more than once.
Follow the example below to programme tracks 6 and 2 on DISC 1 and all
tracks on DISC 3. In this example, each disc has 9 tracks and DISC 3 is
in playing position.
1.
Press the MEMORY button.
,m n
l;'
L
K.
!
TR
-.
2.
Select disc 1 by pressing the DISC 1 button.
The DISC SELECT button on the remote control can also be used.
3.
Select track 6 by turning the MULTI JOG control.
The number buttons on the remote control can also be used.
5.
Select track 2 by turning the MULTI JOG control
6.
Press the MEMORY button.
P F?. 1?
-.
7.
Select disc 3 by pressing the DISC 3 button
8.
Press the MEMORY button.
XL
PR.
3
9.
Press the PLAY/PAUSE
button to start play.
ml-l
I
15
U.u
I
TB
3
El
2
:g+m
6
&b
When all programmed
selections have been played, the player stops
automatically.
"O 0.00 appears on the display.
The programme
contents are retained in memory.
Any attempt to programme
more than 32 selections
will result in
"FULL" being displayed and discontinuation
of the programming.
If a non-existent disc or track number is programmed,
that disc or track
will be skipped during play.
The programme
is cleared when the STOP button is pressed in the
stop mode.
Checking the programme
Each time the MEMORY
button
is pressed
in the stop mode,
the
programmed
details sequentially
appear on the display.
Changing
a programme
To add a new selection to a programme:
1.
In the stop mode, press the MEMORY button repeatedly until"- - --
.- -" is displayed.
2.
Select a disc and track number as explained above.
3.
Press the MEMORY button.
To change a selection:
1.
In the stop mode, press the MEMORY
button repeatedly
until the
selection to be replaced is displayed.
2.
Select a disc and track number as explained above.
3.
Press the MEMORY button.
Note:
Programmed
details cannot be partially deleted or inserted.
/
WHAT TO DO IF ...
If the operation of the unit or display is not normal, even though the
appropriate
buttons have been pressed.
1.
Disconnect the mains lead.
2.
Press the RESET button (rear of the unit) for 30 seconds or more.
3.
Connect the mains lead.
4.
Press the WON button to turn the power on.
5.
Press the desired function button.
Note:
If the unit does not operate correctly,
please contact your nearest
SANYO Authorized
Service Centre.
11
Advertisement
Table of Contents
