Raypak raytherm p-1826 Installation & Operating Instructions Manual page 13

Fig. 13: Poolstat Control
Fig. 14: Control Cover
2. Lace metal strapping or clamps, (NOT PROVIDED)
through the ¾" slots on the cover and fasten
securely to pipe as shown in Fig. 15 & 16. Do not
over-tighten clamps.
Fig. 15: Hose Clamp Slots
Fig. 16: Insert Clamps
3. Remove either the left or right "knock-out" for wir-
ing on the poolstat control as shown in Fig. 17.
Fig. 17: Remove Knockout
4. Attach appropriate conduit and connectors to the
poolstat control.
5. Attach wires to the poolstat wire terminals. See
Fig. 18: Attach Wires
Fig. 18.
6. Install poolstat control to the cover and fasten
cover screws.
7. Poolstat should be mounted level as shown in Fig.
Fig. 19: Mount Level
19.
13