Page 15
INTERNAL DIVERTING BYPASS SYSTEM (UG) Models 0926 thru 1223 with UG...
Page 16
BLENDED WATER TEMPERATURE (THERMOMETER AT HEATER INLET) HEATER OUTLET TEMPERATURE THERMOMETER HEATER THERMOSTAT RECOMMENDED FIELD INSTALLED ISOLATION VALVES FOR SERVICE...
Page 17
Models 2100 thru 4001 BLENDED WATER TEMPERATURE (THERMOMETER AT HEATER INLET) HEATER OUTLET TEMPERATURE THERMOMETER HEATER THERMOSTAT RECOMMENDED FIELD INSTALLED ISOLATION VALVES FOR SERVICE...
Page 18
From Heater To Heater From Filter To Pool...
Page 30
INLET/OUTLET HEADER OUTLET INLET GASKET UNITHERM GOVERNOR WITH POWER ELEMENT...
Page 32
IMPORTANT NOTICE These instructions are primarily intended for the use of qualified personnel specifically trained and experienced in the installation of this type of heating equipment and related system components. Installation and service personnel may be required by some states to be licensed. Persons not qualified shall not attempt to install this equipment nor attempt repairs according to these instructions.
Page 33
Outer jacket very hot (paint blistered) Takes long time to heat pool or spa Liming Leaking at well. Leaking at heat exchanger. Gasket brittle and leaking- (overheated). *Broken refractory caused by shipping damage or improper combustion………………………….. Excessive sooting of heat exchanger…………………………...
ELECTRICAL (ELECTRONIC IGNITION IID) IID Intermittent Pilot System TROUBLESHOOTING HONEYWELL S8600 START TURN GAS SUPPLY OFF. TURN THERMOSTAT (CONTROLLER) TO CALL FOR HEAT POWER TO MODULE (24 V NOMINAL) SPARK ACROSS IGNITER/SENSOR GAP TURN GAS SUPPLY ON PILOT BURNER LIGHTS? SPARK STOPS WHEN PILOT IS LIT? MAIN BURNER LIGHTS?
PARTS REPLACEMENT: Under this Warranty, Raypak will furnish a replacement for any failed part. The failed part must first be returned to Raypak if request- ed, with transportation charges prepaid, and all applicable warranty conditions found satisfied. The replacement part will be warranted for only the unexpired portion of the original warranty.