Handle Assembly - Kenmore Vacuum Cleaner Owner's Manual

Y
HANDLEASSEMBLY
Before assembling your vacuum cleaner, be sure you
have all the parts shown on page 3.
ElectricalShock Hazard
Do not plug into electrical supply untilassembly Is
complete. Failureto do so could resultin electrical
shock or injury.
Handle
Hooks
Handle
Screw
and Hole
Handle
Scn_
Back Of I
v-uum°' ll I
Remove the handle screw located just below the top
edge of the back of the vacuum, (see illustration
above).
Position the handle so the cord hooks are toward the
back of the cleaner.
Insert the handle
into the opening at
the top of the
vacuum.
Align the handle
screw in the hole in
the handle and the
handle screw hole
in the back of the
vacuum.
Insert the handle
screw so it passes
through the back of
the vacuum into
the handle.
In Vacuum
Begin to tighten the screw with your fingers. It may
be necessary to adjust the handle slightly.