Advertisement
VACUUM
WARNING
personal Injury and Product Damage Hazard
• DO NOT use outlets above counters. Damage to
items in surrounding area could occur.
• Use care in plugging in the vacuum. The vacuum
should be in the OFF position.
Quick Release
i. Turn the top
cord hook down.
2. Pull the cord off
the hook.
3. Once the cord is
removed,
lock the
cord into place by
forcing it into the
locking notch on the
body of the cord
hook as shown.
4. Plug the cord into
120 volt o_ttlet locat-
ed near the floor,
Locking
Notch
NOTE: To reduce the risk o f electric s hock,this v acu-
um cleanerhas a polarized plug,(one blade is wider
than the other). T his plugwill f it i na polarized outlet
onlyone way. If the plug does not fit f ully i nthe out-
let, r everse the plug.If it still
does notfit, contact a
qualified electrician to install
the proper outlet. D o
notchange the plug inany way.
Foot Rest For
Handle Release
5. Place your foot on the pad at the left rear of the
cleaner and pull back on the handle until it releases
from its upright position,
6. With your left hand reach down and push the "ON-
OFF" switch to the right. The cleaner will now staff.
To shut the cleaner
"OFF" reach down and push the
switch to the left, Raising the handle up will catch the
handle support spring and hold the handle in the
upright position.
W TOSELECT
PROPER HEIGHT
FORCLEANING
This cleaner
has four heights in which the nozzle can
be set up off the floor for the various surfaces you are
trying to clean.
The height adjust knob is on the nozzle over the light
lens. The settings a re:EX LOW, LOW, MED and HIGH.
Height Adjust Knob
To adjust the
height, grasp
the knob and
move it to the
desired setting,
Adjustcleaner
heights by refer-
ring to the chaff
below to match
the type of sur-
face to be
cleaned:
EX LOW: very low pile.
LOW: short or medium pile.
MED: medium to long pile.
HIGH: shag carpet,long pile, p lush, scatter rugs.
Place unit in "HIGH" when using attachments to pre-
vent possible floor damage.
Advertisement
