Table of Contents
Advertisement
General Information
Incoming Inspection
Installation of the Calibration Definitions
The calibration definitions for the kit may be permanently installed in the internal
memory or hard disk of the network analyzer.
If the calibration definitions for the kit are not permanently installed in the network
analyzer, they must be manually entered. Refer to your network analyzer user's guide for
instructions.
Equipment Required but Not Supplied
Connector cleaning supplies and various electrostatic discharge (ESD) protection devices
are not supplied with the calibration kit but are required to ensure successful operation of
the kit. Refer to
Table 6-2 on page 6-4
for ordering information.
Incoming Inspection
Verify that the shipment is complete by referring to
Table 6-1 on page
6-3.
Check for damage. The foam-lined storage case provides protection during shipping. Verify
that this case and its contents are not damaged.
If the case or any device appears damaged, or if the shipment is incomplete, contact
Agilent Technologies. For contact information, see
Table 5-1 on page
5-3. Agilent will
arrange for repair or replacement of incomplete or damaged shipments without waiting for
a settlement from the transportation company.
When you send the kit or device to Agilent, include a service tag (found near the end of this
manual) with the following information:
• your company name and address
• the name of a technical contact person within your company, and the person's complete
phone number
• the model number and serial number of the kit
• the part number and serial number of the device
• the type of service required
• a detailed description of the problem
85038A/F/M
1-3
Advertisement
Table of Contents
