Omega DP400TP User Manual page 36

11 Totalizer
Visualize on corresponding page the total value of measured process
considering the sensor signal as unit/time value (ex. if full-scale of the
connected sensor is 2000m3/hour, parameter 11 Totalizer has to be
selected as Hour and display will visualize the total fluid volume from the
last RESET/START signal till present).
Disabled
Second
Minute
Hour
12 Sum function
Enable the sum function and its dedicated page. Allow to sum the process
value to a variable.
Disabled (Default)
Enabled
13 Store
Enable to store in EEPROM the values of peaks, totalizer, sum function and
zero tare. If disabled, at starting the above-mentioned values start from 0.
The storing is done automatically every 5 minutes.
Disabled (Default)
Enabled
14 Conversion filter
ADC Filter: defines the type of digital filter applied to the reading of the
analog input.
Filter 4th ord.
No filter
Average 2 samp.
...
Average 20 samp.
When average increase, control loop speed slows down.
Default: Average 10 samp.
36 -
DP400S - User manual
Display visualizes process value (Default)
Display visualizes rate in unit/s
Display visualizes rate in unit/min
Display visualizes rate in unit/hour