Table of Contents
Advertisement
Press
" n "
2
and " m "
3
"Ok"
"◊%" and
4
"◊mV"
" m "
5
" n "
6
7
">0<"
18 -
DP400S - User manual
Display
Full-scale% value: enter the
% of full-scale value at which
the calibration of upper limit
will be performed.
Value mV/V: enter the
correct value mV/V of the
sensor.
Full-scale% value: confi rm
the selected %.
Value mV/V: Confi rm the
selected mV/V value.
Press to go back to settings
of calibration % or to
settings of mV/V value of the
sensor.
Set the value on minimum.
Set the value to maximum
Set the virtual zero value
Visualization will automatically
switch to sensor calibration page
where real-time value read by
the device is visualized.
Visualization will automatically
switch to the page for the setting
of full-scale % or mv/V value.
Place the sensor on its maximum
operating position (related to
Upper limit).
To exit standard procedure
press "Esc". For zero setting place
the sensor on the zero point
(tare).
Press "Esc" to exit procedure.
Min
Do
Max
Zero
Advertisement
Table of Contents
