Vocera T1000 User Manual page 146

B1000A and B2000 Regulatory Notices
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause unwanted operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against interference in a commercial
or residential installation. There is no guarantee, however, that interference will
not occur in any particular installation. If this equipment does cause interference
with radio or television reception, the user should try to correct the interference
by employing one or more of the following:
• Reorient or relocate the receiving antenna on the affected equipment.
• Increase the separation between the affected equipment and the badge.
• Consult the dealer or an experienced technician for help.
Any changes or modifications to this device not expressly approved by the
party responsible for compliance could void the user's authority to operate the
equipment.
THIS BADGE MEETS THE FCC REQUIREMENTS FOR EXPOSURE TO RADIO
FREQUENCY ENERGY (SAR).
Your wireless badge is a radio transmitter and receiver. It is designed and
manufactured not to exceed the emission limits for exposure to radio frequency
(RF) energy set by the Federal Communications Commission of the U.S.
Government. These limits are part of a set of comprehensive guidelines
that establish permitted levels of RF energy for the general population. The
guidelines are based on standards that were developed by independent
scientific organizations through periodic and thorough evaluation of scientific
studies. The standards include a substantial safety margin designed to assure
the safety of all persons, regardless of age and health. The exposure standard
for wireless communications devices employs a unit of measurement known as
the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg.
Tests for SAR are conducted using standard operating positions, as applicable
to this device, specified by the FCC. The standard incorporates a substantial
margin of safety to give additional protection for the public and to account for
any variations in measurement. Before a badge is available for sale to the public,
sample units must be tested by a certified regulatory lab to verify that they do
not exceed the limit established by the government-adopted requirement for
safe exposure.
USE ONLY APPROVED ACCESSORIES
146 ··· Vocera User Guide