Table of Contents
Advertisement
Driver Installation
4.2. Installing Ultra320 SCSI Controller
4.2.1.
Installing Windows 2000 with an Ultra320 SCSI Controller
1. Start your system with the Windows 2000 Boot CD-ROM in the
CD-ROM drive. Note: When using a CD-ROM drive to install Windows
2000 from the bootable CD-ROM, make sure Bootable CD-ROM support
is enabled. This is done through the System BIOS Setup Utility.
2. Press F6 when this message is displayed: "Press F6 if you need to install
third-party SCSI drivers".
3. When prompted, press "S" to supply the new driver.
4. Insert the Adaptec Ultra320 FMS driver disk when the setup prompts you
to insert the manufacturer supplied disk into drive A, and press Enter.
5. The screen displays the adapter drivers supported on the disk. Select
"Adaptec Ultra320 SCSI Cards (Win2000)" and continue with the rest of
the Windows 2000 installation.
6. Your system will reboot once more to finish setting up Windows 2000.
4.2.2.
Installing the Driver when Windows 2000 is Already Installed
1. Start Windows 2000. Windows 2000 will automatically discover the new
hardware and start the Found New Hardware Wizard to guide you through
the device driver installation.
2. At the Welcome to the Found New Hardware Wizard window, select
Next.
3. On the Install Hardware Device Drivers screen, select Display a list of the
known drivers for this device, and click Next.
4. Select the Have Disk button. You will be prompted to insert the
manufacturer supplied disk. Insert the Adaptec Ultra320 FMS driver disk
in your disk drive and enter the following path, then click OK.
a:\win2000
5. Select the Adaptec Ultra320 driver from the list, then click the Next
button.
6. Click the Next button again to confirm the installation of the driver. You
may be prompted with this warning message: "The software you are about
to install does not contain a Microsoft digital signature ..." Ignore the
4-3
User's Manual
Advertisement
Table of Contents
