Abit WI-2P User Manual page 35

BIOS Setup 3-5
Drive A
This item sets the type of floppy drives installed.
[None]: No floppy drive installed
[360K, 5.25 in.]: 5.25-inch standard drive; 360KB capacity
[1.2M, 5.25 in.]: 5.25-inch AT-type high-density drive; 1.2MB capacity
[720K, 3.5 in.]: 3.5-inch double-sided drive; 720KB capacity
[1.44M, 3.5 in.]: 3.5-inch double-sided drive; 1.44MB capacity
[2.88M, 3.5 in.]: 3.5-inch double-sided drive; 2.88MB capacity
Halt On
This item determines whether the system stops if an error is detected during system
boot-up.
[All Errors]: The system-boot will stop whenever the BIOS detect a non-fatal error.
[No Errors]: The system-boot will not stop for any error detected.
[All, But Keyboard]: The system-boot will stop for all errors but keyboard error.
[All, But Diskette]: The system-boot will stop for all errors but disk error.
[All, But Disk/Key]: The system boot will stop for all errors but disk or keyboard
error.
Base Memory
This item displays the amount of base memory installed in the system. The value of
the base memory is typically 640K for system with 640K or more memory size
installed on the motherboard.
Extended Memory
This item displays the amount of extended memory detected during system boot-up.
Total Memory
This item displays the total memory available in the system.
User's Manual