Craftsman 113.24907 Owner's Manual page 3

19.
20.
NEVER STAND ON TOOL
Serious injury could occur if the tool is
tipped.
Do not store materials above or near the
tool such that it is necessary to stand on
the tool to reach them.
CHECK DAMAGED PARTS
Before further use of the tool, a guard or
other part that is damaged should be care-
fully checked to ensure that it will operate
properly and perform its intended function.
Check for alignment of moving parts, binding
21.
22.
of moving parts; breakage of parts, mount-
ing, and any otherconditions that may affect
its operation. A guard or other part that is
damaged shoutd be properly repaired or
replaced.
DIRECTION OF ROTATION
Consult owners manual for proper direction
of spindle rotation.
NEVER LEAVE TOOL RUNNING UN-
ATTENDED
Turn power off. Don't leave tool until it
comes to a complete stop.
additionam safety instructions for copy-crafter
Before operating the Copy-Crafter read and understand your Lathe and Copy-Crafter
owner's manuals and affixed Warnings.
I, Preparation of workpiece 2.
Before attempting to copy (duplicate) a
spindle turning, rough out the workpiece
using the conventional lathe tools and lathe
tool rest. Use lowest speed when starting -
never exceed recommended speed on lathe
"spindle speed" chart.
Before attempting to copy (duplicate) a
faceplate turning, saw the corners off the
workpiece.
.
Do not force the cutting tool into the re-
volving workpiece, or attempt to take a
heavy cut. This could damage the workpiece
or cause it to come out of the lathe. This is
especially true of long workpieces of small
diameter.
Always take light cuts and make sure that
the centers are seated properly in the work-
piece.
Wear safety goggles at all times. Wear face
shield or mask if operation is dusty.
4. Stop operation immediately if the turning
vibrates or if abnormal noise occurs.
Mount the workpiece (see "Getting to Know
Your Copy-Crafter"). Use lowest speed when
starting - never exceed recommended speed
on Lathe "spindle speed" chart. Use con-
ventional lathe tools and toot rest to turn
periphery, Use conventional lathe tools and
too! rest (or Bowl Turning Tool Rest -
Cat. No. 9-24903) for internal turnings deeper
than 3/4 inches.
5. Tighten all screws, nuts and Iocknuts
securely before operating.
6. Note and follow the instructions found on
the WARNING label which appears on the
flange of the platform channel.
o J
m___ 'I'!I"IP"! ,, i_'"' , ,,l! ,I,,!,11 ,ll I, I 'l Ill , i, '1' !111 I1'1'11
WEAR YOUR
tOGGLES),
The operation of any power tool can result in
foreign objects being thrown into the eyes, which
can result in severe eye damage. Always wear
safety goggles complying with ANSI Z87.1 (shown
on Package) before commencing power tool
operation. Safety Goggles are available at Sears
retail or catalog stores.