Craftsman 113.24907 Owner's Manual page 10

8. CUTTING TOOL
I
7. CRADLE
6. TOOL POST /
5. CONTROL
KNOBS
4. TO(
BASE
3. BRACKETS
\
\
9. FOLLOWER PINS
2. VERTICAL CHANNELS
t
1. FRONT CHANNEL
_ 12_
i
13. CENTER SCREW
10. BED PLATE
1. FRONT CHANNEL...comfortably supports your
hands while maneuvering the Cutting Tool.
2. VERTICAL CHANNELS...support the Tool Post Base
and the Brackets.
3. BRACKETS...hold the template or an existing turning.
4. TOOL POST BASE...supports the Tool Post and
contains the control Knobs and the Follower Pins_
There are two strips of very slippery plastic tape glued to
the underside so that it moves easily during operation. Be
careful not to tear these tapes by bumping the base against
a sharp object.
Should the tapes become damaged or worn, replace them.
(See replacement parts list in the back of this manual).
_ 10