Vertical Heel Adjustment - Craftsman 113.19771 Owner's Manual

assembly and alignment
3. To correct "heel" condition proceed as follows:
a. Remove left hand carriage cover.
b. Loosen the yoke clamp handle.
c. Loosen (slightly) the two hex-head screws.
d Rotate the yoke assembly until gap between the
saw blade and square is eliminated.
e. Lock yoke clamp handle and retighten the two
he× head screws.
f, Recheck for "heel" and install carriage cover.
g Loosen carriage lock knob.
NOTE: This alignment procedure will simultaneously set
both yoke index ng positions for blade in and out rip.
HEX HEAD SCREWS
LEFT SIDE OF CARRIAGE
VERTICAL HEEL ADJUSTMENT
1. WiEh sawblade in 90 ° cutoff position, elevate saw and
rotate motor to vertical position (Blade Horizontal) and
c_eck for heel. Make sure bevel lock lever is locked.
2. P_ssition square perpendicular to fence and between
blade and table, as shown lower am1. Do not allow the
square to rest against a "set-out" tooth, it must rest flat
against the blade side.
, ! I1 k
BEVEL, lOCKf " "--T I ol
4.
If the saw blade is parallel with t!le table top {no visible
g,]p appears between the saw blade and square), no
adjustment is requir_:d.
I_ there is a visible gap between saw blade and square, a
bevel heel condition exists and adjustment is required.
a. To correct, unlock bevel lock lever, loosen the rear
motor mount 3/8-16 nut until you can rotate Cam,
and then rotate Can] as shown until gap between
saw blade and square is eliminated.
b. Tighten nut and bevel lock lever and recheck.
c. Reposition motor in crosscut position.
CLOC
SQUARE
_E_c_NII _q_,
r_[] / _1 n
TABLE RIGHT
WRONG
(TURN CAM
COUNTERCLOCKWISE}
'/TR 0 N G
(TUR Iq CAM
CLOCKed1SE}
1
J
17