Perkins 403F-E17T 404F-E22T Operation And Maintenance Manual page 60

60
Maintenance Section
Fluid Recommendations
• The Oil Condition Analysis determines the loss of
the oils lubricating properties. An infrared analysis
is used to compare the properties of new oil to the
properties of the used oil sample. This analysis
allows technicians to determine the amount of
deterioration of the oil during use. This analysis
also allows technicians to verify the performance
of the oil according to the specification during the
entire oil change interval.
Fluid Recommendations
(General Fuel Information)
• Glossary
• ISO International Standards Organization
• ASTM American Society for Testing and
Materials
• HFRR High Frequency Reciprocating Rig
for Lubricity testing of diesel fuels
• FAME
• CFR Co-ordinating Fuel Research
• ULSD
• RME
• SME
• EPA Environmental Protection Agency of
the United States
• PPM
• DPF
• v/v (volume of solute)/(volume of solution)
• CFPP
General Information
NOTICE
Every attempt is made to provide accurate, up-to-
date information. By use of this document you agree
that Perkins Engines Company Limited is not respon-
sible for errors or omissions.
i06675834
Fatty Acid Methyl Esters
Ultra Low Sulfur Diesel
Rape Methyl Ester
Soy Methyl Ester
Parts Per Million
Diesel Particulate Filter
Cold Filter Plugging Point
NOTICE
These recommendations are subject to change with-
out notice. Contact your local Perkins distributor for
the most up-to-date recommendations.
Diesel Fuel Requirements
Perkins is not in a position to continuously evaluate
and monitor all worldwide distillate diesel fuel
specifications that are published by governments and
technological societies.
The Perkins Specification for Distillate Diesel Fuel
provides a known reliable baseline to judge the
expected performance of distillate diesel fuels that is
derived from conventional sources.
Satisfactory engine performance depends on the use
of a good quality fuel. The use of a good quality fuel
will give the following results: long engine life and
acceptable exhaust emissions levels. The fuel must
meet the minimum requirements that are stated in
the table 10 .
NOTICE
The footnotes are of the key part Perkins Specifica-
tion for Distillate Diesel Fuel Table. Read ALL of the
footnotes.
SEBU9075-03