Advertisement
1
SAFETY RULES
The E3640 has been designed with safety in mind. However, no design can
completely protect against incorrect use. Electrical circuits can be dangerous and
even lethal through lack of caution or poor safety practices.
1.1 Read the Instruction Manual carefully and completely so that
you fully understand the instructions before using the tester
Follow the instructions in the Manual for every test. Take all the
recommended precautions. Never exceed the limits of the tester.
1.2 The device under test (DUT) must be de-energised and isolated
before connections are made for any tests.
1.3 Check that the Power selector on the tester is set correctly.
1.4 Always set the voltage control to RESET or set the power switch
to OFF before connecting/disconnecting the earth test lead and
the HV gun probe to/from the "DUT".
1.5 The earth test lead and the HV gun probe must be clean and in
good working order with no broken or cracked insulation.
1.6 The HV gun probe must always be held correctly, with fingers
behind the guard. Never try to defeat the safety trigger mechanism.
1.7 Do not touch the "DUT" during testing with any part of the body.
1.8 Always use the recommended replacement fuses.
1.9 Do not use the tester in wet conditions.
2.0 Please ensure the test lead is pushed fully into the test socket and
locked in position prior to carrying out any tests.
NOTE: This tester should only be used by a competent, suitably trained
person.
-2-
Bump Test
Vibration Test:
Impact Test:
Drop Test:
5.3 ENVIRONMENTAL
Operating Temperature:
Storage Temperature:
Operating Humidity:
Cold Temperature:
Dry Heat:
Damp Heat:
Installation Category II:
Pollution Degree 2:
6. SPARES AND ACCESSORIES
Mains Power Supply Lead:
Earth Lead:
HV Gun Probe:
IEC 68-2-29
BS EN 61010 - clause 8.3
BS EN 61010 - clause 8.2
BS EN 61010 - clause 8.4
-15ºC to +55ºC
-25ºC to +65ºC
80% RH at 40ºC
IEC 68-2-1
IEC 68-2-2
IEC 68-2-3
BS EN 61010 - Annex J
BS EN 61010 - clause 3.7.3.2
MARTL205
METDFH 0366
METDFH 0369
-11-
Advertisement
