JVC HX-Z1R Service Manual page 11

www.freeservicemanuals.info
Removing the bridge board / regulator
board / heat sink
Prior to performing the following procedure, remove
the metal cover, the CD changer mechanism
assembly, the rear panel, the antenna board and
main board.
1. Remove the plastic rivet attaching the stay inner bar
and remove the screw H on the bridge board.
2. Move the inner bar forward and upward to release
from the front section (joint f) and from the bridge
board (two joints h) respectively.
3. Remove the two plastic rivets setting the holding
board fixing the bridge board and the primary board.
Move the bracket board in the direction of the arrow.
4. Disconnect the wire from connector CN212, CN213
and CN214 on the primary board respectively and
remove the band attaching the wires.
5. Disconnect the wire from connector CN701 on the
bridge board.
6. Remove the two screws I attaching the heat sink
bracket and move the heat sink in the direction of the
arrow to release from the base chassis. The bridge
board and the regulator board come off with the heat
sink.
Bridge board
CN701
(See Fig.21 ~ 27)
Band
CN212, CN213
Primary board
CN214
Fig.24
Digitized in Heiloo Netherlands
Plastic rivet
Inner bar
Bridge board
Fig.21
Inner bar
Joint g
Fig.22
Primary board
CN212, CN213
CN214
Plastic rivets
Bridge board
Fig.23
Bridge board
Regulator board
I
Fig.25
3/29/2018
HX-Z1R
H
Joint f
Plastic rivet
Holding board
I
Heat sink
Heat sink bracket
1-11