PLUS eBridge4PCRM IP and PoE+ over Coax Solution Operates with eBridge1PCTX Transceiver or eBridge1ST Mini Transceiver Installation Guide Z1409 I.T.E. 43KC More than just power. Rev. 032113...
Page 2
NetWay16M, and sends its power over the coax to the eBridge 1PCTX or eBridge1ST transmitter under PoE protocol. This enables eBridge4PCRM to be used in a managed manner, allowing for remote camera reset. eBridge1PCTX or eBridge1ST, in turn, delivers that PoE+ compliant power to a PoE enabled camera or IP device.
Connect structured cable from IP camera/device to RJ45 jack marked [PoE Out] (Fig. 3, pg. 4). c. Connect Coax cable from eBridge4PCRM to BNC tether cable marked [Coax] (Fig. 3, pg. 4). Note: eBridge4PCRM is designed to accommodate Megapixel, HD720, HD1080 and VGA (SD) cameras. It is important to note that some high resolution and high frame rate cameras may demand faster headend processing ability, such as a PC graphics card to present a quality image.
Fig. 2 eBridge1PCTX Green LED indicates Power Structured Cable from IP Camera/Device Blue LED Coax indicates Cable from Coax Connection eBridge4PCRM Fig. 3 eBridge1ST Front Rear Flying BNC Flying BNC Connector Connector Structured Cable from Green LED Blue LED Camera/Device...
Four (4) rubber pads Rubber Feet Altronix is not responsible for any typographical errors. 140 58th Street, Brooklyn, New York 11220 USA | phone: 718-567-8181 | fax: 718-567-9056 website: www.altronix.com | e-mail: info@altronix.com | Lifetime Warranty | Made in U.S.A. MEMBER IIeBridge4PCRM F20R...
Need help?
Do you have a question about the eBridge4PCRM and is the answer not in the manual?
Questions and answers