Figure 67: Optional Keypad (P/N 2100652-Xxx); Table 13: Optional Keypad Commands - ABB XSeriesG4 User Manual

NOTE: To view various display items, those items must be pre-programmed for keypad entry. Either program all
the display items for an application or individual display items within the application using PCCU32.

Figure 67: Optional Keypad (P/N 2100652-xxx)

Command Description
Log On Press the ENT key in the lower right corner of the keypad.
Security When prompted, enter the 4-digit security code.
Use the up and down arrow keys located in the upper right corner to scroll through the
Viewing
various instantiated applications (Multiple Tube Device).
Selection After locating the item to change or display, press ENT.
After viewing the item for change, press the = key located in the lower right corner of the
keypad. If entering a negative figure, press the ± key to toggle the minus sign on or off.
Changing
Enter the new figure. Press Enter. NOTE: Only those values that are not live can be
changed from this screen.
When setting up the XRC
a programmed value is changed, it must be valid between the high and low limit;
Validate
otherwise it will return an invalid code. This is called Validate Keypad Entry and must be
set to yes to be active.
Depending on how the display setup is programmed, the Scroll Lock Timeout may be
set. After the programmed time has elapsed, it will return to regular operation. This
Time Out
includes exiting the security system. To re-enter the keypad program, the user will need
to re-enter the security code.
Pressing the SPACE key will have the effect of leaving a blank space(s) between
SPACE
characters during data entry.
Pressing the MENU key and then the group number and item number will take the user
MENU
directly to the specified screen.
Pressing the REG key and then entering the application.array.index of a register will
REG
take the user directly to the specified register.
To exit the program, press the ESC key in the lower left corner once for each level.
ESC
When the screen begins to scroll again, the user has completely exited the program.

Table 13: Optional Keypad Commands

G4
display items, the user may also set data limits so that when
68