Application Licensing Credit Key; Figure 55: Winccu32 Security Code Entry In Meter Id - ABB XSeriesG4 User Manual

WinCCU32 security
Accessing the meter with WinCCU32, regardless of the device security switch (S1) setting, requires the appropriate security
code.
Highlight the appropriate meter, and click Edit ID.
Enter the four-digit Security Code (Figure 55) for that meter.
NOTES: Entering a security code level 2 (previous example) of '5678' gives the WinCCU32 operator full read and
write access to the meter.
There are additional fields stored in WinCCU for uniquely identifying the meter, including fields for entering the lease
holder, producer, operator and buyer. These fields reside on the host computer in the ID manager not in the XRC
NOTE: MODBUS

Application licensing credit key

Credit key driver installation
Step-by-step instructions
The credit key is very easy to install on a computer. Simply plug the USB credit key into an available USB port.
The Windows® operating system will recognize the credit key as new hardware and attempt to install the appropriate
driver with the Found New Hardware Wizard.
Click Next.
It may be necessary to point the wizard to the PCCU32 directory. In the Files Needed screen, select Browse and locate
the driver (usbkey.sys) in the PCCU32 directory.
Once located, click OK.
Software driver installation will commence.

Figure 55: WinCCU32 Security Code entry in meter ID

®
access to the meters is not protected by the security codes.
XSeriesG4 Remote Controller User's manual 2103334 Rev. AB | 59
3 XRCG4 startup
G4
.