On-Board I/O Calibration; Figure 63: Transfer To Credit Key Application Credit Selections; Figure 64: Transferred To Credit Key Application Credits - ABB XSeriesG4 User Manual

On-board I/O calibration

The calibration mode enables the calibration of the analog inputs, analog outputs and pulse inputs.
Hold mode
When calibrating, PCCU will instruct the XRC
G4
prevents real-time XRC calculations from being affected during the calibration. During this time, the XRC
known value at the time calibration mode was entered (This is called the HOLD mode). To exit the hold mode, perform any of
the following:
–
Unplug the DATA cable at the XRC
–
Exit Calibration mode

Figure 63: Transfer to credit key application credit selections

Figure 64: Transferred to credit key application credits

G4
to ignore live values for the period of time the XRC
G4
connector
G4
is being calibrated. This
XSeriesG4 Remote Controller User's manual 2103334 Rev. AB | 65
3 XRCG4 startup
G4
uses the last