Weil-McLain Series 2 Manual page 18

® S
ERIES
Converting boiler to propane — ECO 110
Figure 15 Installing the propane gas orifice (some details omitted for clarity)
7. See Figure 15. Carefully pull the gas valve down until it is free
of the venturi. Securely support the gas valve — DO NOT
leave it dangling.
8. Remove the rubber boot from the gas valve or venturi.
9. Insert the propane gas orifice into the rubber boot. Orifice
must be seated into the inner groove inside the center of the
rubber boot.
10. Install the rubber boot (item 6) guaranteeing that it is firmly
seated on the gas valve opening.
When re-attaching the gas valve, ensure the gas
valve rubber boot (item 6, Figure 15) is in place
and in good condition.
Failure to comply will cause a gas leak, resulting
in severe personal injury or death.
11. Reposition gas valve onto the venturi and reinstall the gas
valve retention bolts (item 3). Make sure the rubber boot is
fully seated on both the gas valve and venturi.
12. Swing the silencer bracket clip (item 5) back into position
and snap on to the gas line.
DO NOT ATTEMPT TO MEASURE VALVE
OUTLET PRESSURE.
damaged by manometer fluid contamination.
Failure to comply could result in severe personal
injury, death or substantial property damage.
18
2
-
G
AS FIRED WATER BOILER
The valve could be
— Boiler Manual
LEGEND for Figure 15
1 Gas valve
2 Venturi
3
Bolts (2) for attaching gas valve to venturi
4 Blower
5 Air silencer bracket clip
6 Propane orifice with boot
13. After installation is complete, attach the propane conversion
label (in conversion kit bag) next to the boiler rating plate.
14. Perform complete start-up sequence (beginning on
page 79), including check for gas leaks and checking for
proper operation.
15. Reinstall jacket door.
The jacket door must be in place during
operation.
with the jacket door removed except for
inspection and testing as directed in this
manual.
(continued)
DO NOT operate the boiler
Part number 550-142-190/1218