Water Fill (continued)
Notice the water bottles are designed
right and left hand units. Position them in
the correct location so the humidifier can
function properly. The water bottles should
rest in the front of the cabinet. Each "E-Z-
must be facing the rear of
Each water bottle is designed
with an =E-
that is easily removable,
Remove the =E-Z-Fill Side-Cap"
side of the water bottle by twisting coun-
Place the opening of the water bottle under
a water faucet (the bottle should fit under a
clearance faucet). Fill with rec-
of cold water
Sears Bacteriostat #42-14900
sary) only. Solid debris could make the
Install the "E-Z-Fill Side-Cap"
Hand tighten only.
Check for possible leaks by performing
1. Grasp bottle handle and hold the bottle
upright over a sink.
2. Press up on valve cap plunger for about
one second to let out a little water.
3. Release the plunger.
4. Listen for air bubbles.
Look for leaks
around the "E-Z-Fill Side-Cap".
5. If you hear air bubbles
or see leaks,
retighten the "E-Z-Fill
repeat steps 1-4.
Wipe off excess water from the bottle.
Position the water bottle back into the unit
by grasping the water bottle handle and
lower it into the cabinet until the bottle sits
on pads at bottom of cabinet. The =E-Z-Fill
must be facing the rear of the
plunger will open and water will flow into
the cabinet. The water level will automati-
cally remain at approximately
1/2" until the
bottles are empty.
The unit is now ready for operation.
Should Always Face Rear