Electrical Hook-Up; Water Fill - Kenmore 758.15420011 Use & Care Manual

Electrical Hook-Up
Locate nearest 120V A.C. wall socket in
the location desired, preferably on
inside wall. With the humidifier in the
desired location, route the electrical cord
safely so no one will trip or upset the
humidifier. Plug in the electrical cord.
WARNING: To reduce the risk of
fire or shock hazard, humidifier
should be plugged into a 120V A.C.
outlet. Do not use extension cords.
If the plug does not fit fully in the outlet,
reverse plug. If it still does not fit,
contact a qualified electrician to install
the proper outlet. Do not change the
plug in any way.
To reduce the risk of electrical shock,
this humidifier has a polarized plug (one
blade is wider than the other). This plug
will fit in a polarized outlet only one
way.
Water Fill
WARNING: To reduce the risk of
shock, always unplug humidifier
before cleaning or servicing.
This humidifier is designed for use with
the two water bottles that are located
under the pivoting lid.
Open the pivoting lid of the humidifier.
Remove the water bottles by lifting them
straight up and out of the cabinet.
Notice the water bottles are designed as
right and left hand units. Position them
in the correct location so the humidifier
can function properly. The water bottles
should rest in the front of the cabinet.
Each "E-Z-Fill Side-Cap" must be facing
the rear of the unit.
Each water bottle is designed with an
"E-Z-Fill Side-Cap" that is easily
removable. Remove the "E-Z-Fill Side-
Cap" on the side of the water bottle by
twisting counterclockwise.
/ Fan Assembly
Pivoting
Lid
Left
"Side=Fill Cap" Should
A|ways Face Rear
6