Replacing A Drive Wheel - Invacare Dragon Vertic Service Manual

®
Invacare - Dragon Vertic
7.12

Replacing a drive wheel

CAUTION! Danger of the wheelchair tipping over or rolling away!
· Prevent the wheelchair tipping over by jacking it up on a wooden chock that is long and wide
enough and placing this underneath the battery box. If the wooden chock is too short or too
high this can lead to the wheelchair tipping over.
· Switch the wheelchair off on the remote.
Required parts/tools:
· 5 mm Allen key
· Wooden chock (approx. 12 x 12 x 30 cm) for jacking up the vehicle.
Information
Please take care of the small parts and observe the sequence in which the component parts are
installed. Please set them out in an orderly fashion so that they can be installed again easily in
the correct sequence.
·
Jack up the vehicle using the wooden chock
(1).
·
Loosen the 4 screws fastening the wheel (1)
using the 5mm Allen key.
·
Remove the wheel from the hub.
·
Installation is carried out in the reverse
order.
SERVICE MANUAL
45