Invacare Dragon Vertic Service Manual page 27

®
Invacare - Dragon Vertic
·
Loosen and remove the four screws (1) on
the motor mounting.
·
Use the metal pin and the hammer to
carefully knock the splint (2) out of the
release lever (1).
·
Pull the release lever (1) together with the
release bar from the old motor (cannot be
seen in the picture on the right).
PLEASE NOTE: Motor damage possible
· Only press the release lever lightly onto the metal bar on the new motor. Do not use a
hammer for this purpose.
Information
It is easiest to fit the release lever before the motor is screwed onto other parts.
·
Carefully press the release lever (1) onto the
rod (2) protruding from the new motor.
·
Press the splint (3) in.
·
Further assembly of the motor is carried out
in reverse order to disassembly.
·
Secure the motor cable using a new cable
tie.
SERVICE MANUAL
27