Clearances; Installation Of Cooktop Into The Kitchen Bench - V-ZUG GK11TGA Operating Instructions Manual

Before connecting the unit, check whether the local connection
conditions (type of gas) are compatible with the unit's setting.
Observe any special conditions imposed by local suppliers
(utilities). The specifications of this cooktop are stated on the
data label located on the bottom of the cooktop base.
A duplicate data label is supplied for adhesion to an accessible
location near the hotplate if the data label on the base of the
hotplate cannot be accessed when the hotplate is installed.

Clearances

A range hood fitted above the top must be installed according
to the installation instructions for the range hood. A minimum
distance of 650 mm is required for a range hood and 750 mm
for an exhaust fan.
Any adjoining wall surface situated within 200 mm from the
edge of any hob burner must be a suitable non-combustible
material for a height of 150 mm for the entire length of the hob.
Any combustible construction above the hotplate must be at
least 650 mm above the top of the burner and no construction
shall be within 450 mm above the top of the burner.
PLQ
A minimum depth of 50 mm from the top of the worktop
surface must be provided for the appliance.
If the base of the hotplate can be touched, a protecting shield
must be fitted.
4
PLQ
The shield must be at least 10 mm from the lowest part of the
hotplate and must be capable of withstanding the appliance
temperatures. Minimum thickness of benchtop is 30 mm.

PD[ 
PLQ


PD[
PLQ
If an oven is positioned below the cooktop the barrier does not
need to be fitted, but a space of 35 mm must be maintained
between the underside of the cooktop and the top of the oven.

Installation of cooktop into the kitchen bench

Side clearances: If the distance measured from the periphery of
the nearest burner to any vertical surface is less than 200 mm,
the surface shall be protected in accordance with clauses
6.10.1.2 of AS/NZS 5601.1.
For cutout dimensions and clearances see Preparing to install.
Installation procedure:
The clips and the adhesive seal (underside of the cooktop) are
factory-fitted: do not under any circumstances remove them.
The seal ensures that the entire work surface will be watertight,
and prevents water seepage.
Fitting the appliance onto the kitchen unit:
Place the cooktop in the correct position then loosen each of
1.
the clips so that they all turn freely (it is not necessary to
completely undo them).
Insert and centre the cooktop.
2.
Press the sides of the cooktop until it is supported around its
entire perimeter.

PLQ
PLQ
PLQ

PLQ
PLQ
PLQ
PLQ
PD[ 
PLQ 
PD[