Component Identification; Reservoirs - Oil Or Grease; Pump; Motors And Drives - Graco LubeMaster Instructions Manual

Component Identification

All LubeMaster Pump Packages include the following
components:
• A reservoir (11) for holding the lubricant.
• A standard pump (101).
Reservoirs (11) - Oil or Grease
• Container for holding oil or grease.
• Grease models include a follower plate.
• The reservoir mounts directly to LubeMaster pump.
Oil Reservoirs
• Reservoirs for oil models have a fill cap (30) and
screen (31), located on top (F
30
F . 2
IG
Grease Reservoirs
13
F . 3
IG
• Grease reservoirs require an external air-free sup-
ply source connected to the fill stud (13).
3A2781A
. 2).
IG
31

Pump (101)

• The pump can be driven by an electric motor or by a
rotating or oscillating machine motion.
• The pump must always be installed with the reser-
voir (11) in a vertical position to ensure proper oper-
ation.
• Always use lockwashers with mounting bolts and
make certain that the bolts are properly torqued.

Motors and Drives

Gear Reducer
NOTICE
Gear reducer units are shipped without lubricant.
Before operating, always check lubricant level and fill
per manufacturers instructions. Operation without lubri-
cant will damage the gear reducer. A table of sug-
gested lubricants is provided on page 24.
Gear reducers have either a 10:1 or 60:1 reduction or an
oscillating clutch drive that can be activated by a
machine motion.
ENTANGLEMENT HAZARD
An exposed drive shaft must be guarded to enclose
the shaft.
• A shaft guard is included if the pump is configured
with a gear reducer.
• The user must provide a guard for any other config-
uration.
Low-Level Switch
Low-level switches protect the system against excessive
pressure and low lubricant levels. The switch provides
an electrical signal when the lubricant level in the reser-
voir is low.
Component Identification
7