System Filling; Manifold Bleeding; Adjusting The Clutch Drive - Graco LubeMaster Instructions Manual

Floor mount or wall mount pump package

Table of Contents

System Filling

After the reservoir is filled as described in Filling the

Reservoir, page 9, fill the remainder of the system by

attaching a hand pump to the system downstream from

the pump manifold block assembly and cycle the hand

pump until the system is filled.

Proper filling of the system will reduce the chance of air

entrapment. The pump block manifold assembly (117,

page 28) must be bled to remove air which will be

trapped inside the pump. Cycle the pump several times

until air-free lubricant is dispensed.

. 7

3A2781A

NOTE: Manual air bleeding procedures are necessary

in the event any system components are loosened, dis-

connected or otherwise removed after their initial instal-

lation.

The degrees of throw of the clutch lever is adjustable

from 12 to 60 degrees. Table 1 (page 12) provides the

minimum/maximum pump outputs. The actual pump

output for your installation may be computed by using

the Calculating Pump Output procedure (page 12).

Using the clutch lever diagram provided in F

mine the anticipated clutch lever throw angle.

Setup

. 7 deter-

Table of Contents