Display Elements; Device State - Hirschmann Octopus II User Manual

1.6

Display elements

After the supply voltage is set up, the software starts and initializes itself.
Afterwards, the device performs a self-test. During this process, various
LEDs light up.
1.6.1

Device state

These LEDs provide information about conditions which affect the operation
of the whole device.
ACA
Power
LED Display
Power Supply voltage
ACA ACA21-M12/
ACA22-M12
storage medium
(USB interface)
RM Ring Manager
Status Device Status
30
RM
Status
Color Activity
— none
yellow lights up
flashes 4 times
a period
green lights up
— none
green lights up
flashes 3 times
a period
yellow lights up
— none
green lights up
flashes 1 time
a period
yellow lights up
— none
green lights up
red lights up
flashes 1 time
a period
flashes 4 times
a period
Meaning
Supply voltage is too low
Device variants with redundant power
supply:
Supply voltage 1 or 2 is on
Software update is running. Maintain the
power supply.
Device variants with redundant power
supply:
Supply voltage 1 and 2 is on
Device variants with single power supply:
Supply voltage is on
ACA storage medium not connected
ACA storage medium connected
Device writes to/reads from the storage
medium
ACA storage medium inoperative
No redundancy configured
Redundancy exists
Device is reporting an incorrect
configuration of the RM function
No redundancy exists
Device is starting and/or is not ready for
operation.
Device is ready for operation.
Characteristics can be configured
Device is ready for operation.
Device has detected at least one error in
the monitoring results
The boot parameters used when the
device has been started differ from the
boot parameters saved.
Start the device again.
Device has detected a multiple IP address
Installation Octopus II
Release 06 10/2018