mangOH Red User Manual page 33

Table 3-8: SW401—Module Signals Control
Signal
PWR_ON
WIFI_UART1_TX
VCC_3V7_ULPM
HL_MODE
BATT_TS+
CONS_DIR
TP1_BOOT
LowPower_RESET
Rev 3 Sep.18
Dip On / Off
On (Default) Enable CF3 module's POWER_ON signal
1
Off Disable POWER_ON signal
Enable CF3 module's firmware download
(recovery) mode.
On
2
Note:
Off (Default) Normal operation
While in ULPM, CF3 module and accessories
On (Default)
receive power.
3
While in ULPM, only the CF3 module and
Off
accessories receive power.
When combined with LowPower_RESET,
On
indicates that board is in HL mode.
4
When combined with LowPower_RESET,
Off (Default)
indicates that board is in WP mode.
On Enable backup battery charging.
5
Off (Default) Disable backup battery charging.
Console USB connector accesses the Wi-Fi/
Bluetooth module's console.
On
Note:
6
module, set CONS_DIR OFF and
WIFI_UART1_TX ON.
Console USB connector access the CF3
Off (Default)
module's console.
Enable CF3 module's TP1 (boot) signal
On functionality. Pull the signal low to enter
7
download mode for firmware updates.
Off (Default) CF3 module functions normally.
When combined with HL_MODE, indicates
On
that board is in WP mode.
8
When combined with HL_MODE, indicates
Off (Default)
that board is in HL mode.
State
Similar functionality to TP1_BOOT
To download firmware to the Wi-Fi
33 41110400