mangOH Red User Manual page 11

7. Power up the mangOH Red:
a. Use a micro-USB cable to connect the mangOH Red USB connector that you selected as the power
supply in Step 6, and plug the other into your computer or AC adapter.
Figure 2-5: Connecting Power to the mangOH Red
When the mangOH Red is powered, the Power LED turns solid green.
Figure 2-6: Power LED Location
Tip:
If the Power LED does not turn on:
• Make sure the cable is securely connected to the correct USB port (as shown in the image).
• Make sure the jumper block is on the correct pins (as shown in the image).
8. Optionally (only if power is supplied from the computer, not an AC adapter), use a second mini-USB cable to
connect the remaining mangOH Red USB connector (CF3 USB or Console) to your computer. (This enables
you to display diagnostic messages in one terminal window and work in another, as described in
Access on page 39.)
The mangOH Red is now ready to be used.
Rev 3 Sep.18
CF3 USB connector
(bottom side of board)
11
Power LED
Console
41110400