Initial Setup - mangOH Red User Manual

mangOH Red User Guide

2.3 Initial Setup

To begin using the mangOH Red, set up your hardware and software:
1. Install / Update Windows
2. Install a Terminal Emulator. See page 37.
3. Verify the SW401 dipswitch pins are set correctly:
a. If the dipswitches are covered with a protective film, remove it:
Remove this film
Figure 2-3: SW401 Dipswitch Location
b. Make sure the dipswitches are set as follows:
· ON—1,3,5,8
· OFF—2,4,6,7
Note: Pin 1 must be ON to allow the module to power up as soon as power is supplied. If pin 1 is OFF, you must press
SW402 after power is supplied to power up the module.
Figure 2-4: SW401 Dipswitch Recommended Settings
4. If you will be establishing a mobile network connection, insert a micro-SIM. See
page 18.
5. Connect Antenna(s). See page 17.
6. Select USB Power Supply. See page 15.
Rev 3 Sep.18
Driver. See page 36.
10
Inserting a micro-SIM Card
41110400
SW402 (on edge)
on