3: Hardware Setup and Features
This chapter describes:
•
How to install various components on the mangOH Red
•
Available connectors
•
How to configure and control features using connectors and switches
3.4 Insert/Remove Embedded Module
The mangOH Red has one CF3 module socket. (For a list of supported Sierra Wireless CF3 modules, see
Table 1-2
on page 7.)
Note: The mangOH Red comes with a CF3 module (WP76xx, WP77xx, WP8548, etc.) pre-installed.
To insert a CF3 module on the mangOH Red board:
1. Place the mangOH Red face-up.
2. Insert the CF3 module—Hold the module above the socket and line up the triangles on the module and
socket, then place the module in the socket. The module should drop into place when you have it aligned
properly. Do not insert at an angle as this may damage the socket pins.
Figure 3-1: mangOH Red—Module Insertion
Rev 3 Sep.18
The triangle on the label
matches the position of the
triangle on the socket.
13
3
41110400