Disposal - Hoshizaki KM-230BAJ Service Manual

4) Close the door.
5) Replace the louver in its correct position.
6) Close the icemaker water supply line drain valve.
3. On water-cooled model only, remove the water from the water-cooled condenser:
1) Make sure the control switch is in the "OFF" position and the appliance is unplugged
from the electrical outlet.
2) Remove the top and left side panels.
3) Close the condenser water supply line shut-off valve. If connected to a closed loop
system, also close the condenser return line shut-off valve.
4) Open the condenser water supply line drain valve. If connected to a closed loop
system, also open the condenser return line drain valve.
5) Attach a compressed air or carbon dioxide supply to the condenser water supply line
drain valve.
6) Open the water regulating valve by using a screwdriver to pry up on the spring
retainer underneath the spring. While holding the valve open, blow out the
condenser using the compressed air or carbon dioxide supply until water stops
coming out.
7) Close the condenser water supply line drain valve. If connected to a closed loop
system, also close the condenser return line drain valve.
8) Replace the left side and top panels in their correct positions.
VII. Disposal
The appliance contains refrigerant and must be disposed of in accordance with
applicable national, state, and local codes and regulations. Refrigerant must be
recovered by properly certified service personnel.
49