Hoshizaki KM-230BAJ Service Manual page 21

CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews are
securely in place after the icemaker is serviced. Make sure that none have fallen into
the ice storage bin.
1) Remove the louver. Move the control switch to the "OFF" position, then unplug the
appliance.
2) Remove the water tank (see "IV. C. WATER TANK"). The bin control switch is
located as shown below when viewed from the front.
3) Remove the top panel and the rear panel.
4) Disconnect the connector of the bin control switch lead (black) covered with a
silicone hose and remove the lead wire from the grommet.
5) Loosen the thumbscrew on the right side.
6) Remove the thumbscrew on the left side. Shift the bin control switch to the left to
remove.
Shift to the left
and remove
WARNING
Bin Control Switch
Remove Loosen
20
Fig. 1
Fig. 2