Installing A Management Module - Dell EMC PowerEdge MX7000 Installation And Service Manual

Figure 39. Management Module jumper
4 Replace the Management Module.
The existing Management Module passwords are not disabled (erased) until the system boots with the jumper on pins 1 and 2.
However, before you assign a new system and/or setup Management Module password, you must move the jumper back to pins 2 and
3.
NOTE: If you assign a new system and/or setup Management Module password with the jumper on pins 1 and 2, the system
disables the new Management Module password the next time that it boots.
5 Reconnect the system to its electrical outlet, and turn on the system, including any attached peripherals.
6 Power off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
7 Remove the Management Module.
8 Move the jumper on the Management Module from pins 1 and 2 to pins 2 and 3.
9 Replace the Management Module.
10 Reconnect the system to its electrical outlet, and turn on the system, including any attached peripherals.
11 Assign a new system and/or setup Management Module password.

Installing a management module

Prerequisite
1 Follow the safety guidelines listed in
Steps
1 Align and push the management module into the enclosure.
2 Close the release lever to lock the module in place.
52 Installing and removing system components
Safety instructions.